

Deliver to
ColumbusDeliver to
ColumbusShiped By: AliExpress
OverviewQU232M is an external GPS receiver, the protocol is NMEA 0183, the default baud rate is 4800. Supports GPS/WAAS+QZSS+SBAS, supports up to 66 s…
Overview
QU232M is an external GPS receiver, the protocol is NMEA 0183, the default baud rate is 4800. Supports GPS/WAAS+QZSS+SBAS, supports up to 66 satellite tracking channels, and with satellite-based enhanced satellites, the horizontal positioning accuracy can reach 2 meters.
QU232M also supports SBAS (Satellite-Based Augmentation System) which is the generic name given to the differential signal transmitted by various local geo-stationary satellites. SBAS allows GPS receiver to remove errors in the position due to environmental conditions and improves accuracy down to <2m. Using WAAS in the US and EGNOS in Europe the QU232M will automatically switch to differential SBAS mode when available.
This product is compatible with Garmin, raymrine and other GPS sensors. Please make sure your device has an NMEA 0183 interface and operates at 4800 baud before purchasing.
Factory configuration:
Baud rate: 4800 bps
NMEA messages: GGA RMC GLL VTG GSV GSA ZDA
If you need to change the configuration, please inform the customer or leave a message before placing an order.
Specification
Chipset:MT3339
Protocol:NMEA 0183
Support Frequency:GPS L1,SBAS L1,QZSS L1
Channels:66 Searching Channel
Horizontal Accuracy:2.0m CEP 2D RMS SBAS Enable (Typical Open Sky)
Speed Accuracy:0.05m/sec 95% (SA off)
Tracking :-165dBm
Reacquisition:-160dBm
Cold start:-148dBm
Hot Start:30s
Warm Start:2s
Cold Start:1s
Baud Rate:4800bps-921600bps,Default 4800bps
Signal Level:RS232
NMEA Sentence:GGA, GSA, GSV, RMC,GSA,GSV
Nav Rate:Max 10Hz,Default 1Hz
Altitude:<50000m
Velocity:<515m/s
Acceleration:<4G
Voltage:DC Voltage 3.3V-5.5V,Typical:5.0V/7-28V,Typical:12.0V
Current:30mA/5V,20mA/12V
Dimension:D11cm*H18cm
Weight:310g
Cable Length:5 meters
Operating Temp:-45℃-+85℃
Storage Temp:-45℃-+105℃
Waterproof Level:IP67
Pin Definition
Connection Diagram
Please note that do not connect the GPS signal wires (TX RX) to the positive pole of your power supply, otherwise it will immediately damage the antenna.
If you don't know how to connect wires, please provide the NMEA 0183 interface description of your device to customer service and request assistance.
Product Test
NMEA Format
In the default configuration, the NMEA-GSV GSA ZDA messages are sent at 4-second intervals to avoid overflow in the TX buffer.
Size